LIS3MDL Magnetometer Sensor

Magnetic field strength (in µT) measured by LIS3MDL sensor connected to Nucleo/STM32L475-Discovery board, along the x-, y- and z- axes, specified as a row vector [x,y,z].

Dependencies

This output port appears only if you select the Magnetic Field (µT) parameter.

Data Types: double

Temperature (in ℃) measured by LIS3MDL sensor connected to Nucleo/STM32L475-Discovery board.

Dependencies

This output port appears only if you select the Temperature (℃) parameter.

Data Types: double

Status of magnetic and temperature measurements, specified as a 1-by-2 vector. 0 indicates that the data read is new, 1 indicates that the data read is not new, and -1 indicates that the corresponding output is not selected.

Dependencies

This output port appears only if you select the Status parameter.

Data Types: int8

Select this parameter to use onboard sensors.

Specify the I2C module on the board. The I2C bus frequency, serial clock (SCL) pin and serial data (SDA) pin are taken according to the corresponding I2C module entry in the configuration parameters.

Dependencies

To enable this parameter, deselect the Use onboard sensors parameter.

Select this parameter to set Magnetic Field as one of the output ports.

Select this parameter to set Temperature as one of the output ports.

Select this parameter to set Magnetic Field Status as one of the output ports.

Specify how often this block reads the data from the LIS3MDL sensor. When you set this parameter to -1, Simulink determines the best sample time for the block based on the block context within the model.

Select the full scale for measuring linear acceleration (the range of acceleration that the sensor needs to measure).

Select the output data rate at which magnetometer data is sampled.