Data bitrate (kbps)
R2026bData bit rate for CAN FD communication
Since R2026b
Model Configuration Pane: Hardware Implementation / Hardware board settings / Target hardware resources / Groups / CAN
Description
Specify the bit rate used during the data phase of CAN FD communication.
Dependencies
To enable this parameter, set Interface configuration to
Specify via Simulink and set CAN protocol
to CAN FD. To enable this parameter for additional interfaces, set
Number of interfaces to a value greater than or equal to the
interface number.
Settings
2000 (default) | dynamic (depends on nominal bitrate)Select the data phase bitrate in kilobits per second.
2000(default)2000 kbps (2 Mbps) data phase bitrate. This provides 4 times throughput improvement over the default 500 kbps nominal bitrate during the data phase.
- Other values
Available data bit rates are dynamically calculated based on the selected nominal bitrate. The MCP2518FD controller supports data bit rates up to 8000 kbps (8 Mbps). The maximum achievable data bitrate depends on bus length, connector quality, and transceiver capabilities.
Recommended Settings
No recommendation.
Programmatic Use
| No programmatic use is available. |
Version History
Introduced in R2026b
