Main Content

Variable Phase Shift

Model variable phase device

expand all in page
  • Variable Phase Shift block

Libraries:
RF Blockset / Circuit Envelope / Elements

Description

The Variable Phase Shift block controls the phase of the output signal of a RF Blockset™ circuit. The block uses a Simulink® signal to control the phase of the circuit. One input terminal is for the Simulink control signal and one input terminal is for the RF Blockset signal.

Phase shifter are commonly used in phased array antenna systems. In these systems, electronically controlled phase shifters steer the antenna beam in space. Phase shifters are also used in test and measurement systems.

Examples

Vary Phase Of Signal During Simulation

Vary Phase Of Signal During Simulation

Use the Variable Phase Shift block to shift the phase of a sine wave to 180 degrees.Use Repeating Sequence Stair block as a Simulink control signal to control the phase of the signal. To see the variation in phase to 180 degrees, first open and run the model. During simulation, change the value of the Simulink control signal to 90 degrees and see a change in phase in the Output Scope.

Ports

Input

expand all

Simulink control signal, specified as a scalar.

Data Types: double

Parameters

expand all

Angle units for controlling the phase of the signal, specified as rad for radians or deg for degrees.

Reference impedance for phase shifter, specified as a scalar or vector of positive scalars in ohms.

Note

For non-50 ohm reference impedances, the model inside the Phase Shift block is normalized to 50 ohms.

Select this parameter to ground and hide the negative terminals. To expose the negative terminals, clear this parameter. By exposing these terminals, you can connect them to other parts of your model.

Version History

Introduced in R2016b

expand all

See Also

| | |