Main Content

Communicate Data Between Raspberry Pi and Sense HAT Using NNG Blocks

This example uses:

Open Model

This example shows how to use the NNG Send and NNG Receive blocks from the Simulink® Support Package for Raspberry Pi® Hardware to establish communication between the Raspberry Pi hardware and Sense HAT using the nanomsg next generation (NNG) library.

The NNG Send and NNG Receive blocks support the publish/subscribe protocol.

Consider Raspberry Pi acting as a subscriber and Sense HAT acting as a publisher. The HTS221 humidity sensor on the Sense HAT detects the ambient temperature. Raspberry Pi subscribes to the URL for displaying the ambient temperature on the Display block in the Simulink model.

Consider Sense HAT acting as a subscriber while Raspberry Pi acting as a publisher. Raspberry Pi sends the message "Hello!" to Sense HAT. The Sense HAT subscribes to the URL for displaying the message on the 8x8 LED matrix display.

For more information on nanomsg next generation (NNG) library, refer to NNG: Lightweight Messaging Library.

Prerequisites

Execute this command on the Raspberry Pi terminal to install both the modules.

sudo pip3 install sense_hat pynng

Required Hardware

  • Raspberry Pi hardware

  • Raspberry Pi Sense HAT

  • Micro USB cable

Connect Raspberry Pi to Sense HAT

Attach Sense HAT to the Raspberry Pi expansion header. Make sure that you power down your Raspberry Pi before attempting to attach the Sense HAT.

Configure Simulink Model and Calibrate Parameters

This example uses a preconfigured Simulink model from the Simulink Support Package for Raspberry Pi Hardware. To open the Simulink model, run this command in the MATLAB® Command Window.

Open the raspberrypi_nng_sensehat Simulink model.

In the NNG Send block, set the IPC name parameter to senseDisplay. In the NNG Receive block, set the IPC name parameter to senseTemp.

Execute Python Script to Start Publish/Subscribe Process

The senseDis.py Python® script establishes a connection between the Sense HAT and Raspberry Pi hardware board and starts a process to publish and subscribe data. In the script, ensure to configure the URL as displayed in the NNG Send and NNG Receive blocks.

Follow these steps to execute the Python script on your Raspberry Pi hardware.

1. Establish a connection with the Raspberry Pi board.

mypi = raspberrypi('ipaddress','username','password')

2. Locate the full path of the senseDis.py file.

str = which('senseDis.py')

3. Copy the senseDis.py file from your host computer to Raspberry Pi hardware.

putFile(mypi,str,'/home/username')

4. Execute senseDis.py file on your Raspberry Pi hardware.

sudo python3 /home/username/senseDis.py

The terminal on the Raspberry Pi hardware displays the ambient temperature and the "Hello!" message continuously.

Run Simulink Model in External Mode (Monitor and Tune)

On the Hardware tab of the Simulink model, in the Mode section, select Run on board and then click Monitor & Tune. Observe the ambient temperature on the Display block in the Simulink model.

Observe the message "Hello!" on the 8x8 LED matrix on the Sense HAT.