HDL Verifier™ automates the verification of HDL code on FPGA boards by providing connections between your FPGA board and your simulations in Simulink® or MATLAB®.
FPGA-in-the-loop (FIL) enables you to run a Simulink or MATLAB simulation that is synchronized with an HDL design running on an FPGA board.
FPGA data capture is a way to observe signals from your design while the design is running on the FPGA. It captures a window of signal data from the FPGA, based on your configuration and trigger settings, and returns the data to MATLAB or Simulink.
MATLAB AXI master provides access to live on-board memory locations from MATLAB. You must include the MATLAB AXI master IP in your FPGA design.
To use each of these features, you must have a supported FPGA board connected to your MATLAB host computer using a supported connection type, and a supported synthesis tool.
This support package enables FPGA-in-the-loop simulation for the boards in the table. FPGA data capture and AXI master are available on those boards that have JTAG USB Blaster I or USB Blaster II connections.
AXI Master is supported is supported over Ethernet for Intel® Arrow® MAX® 10 DECA boards.
AXI Master is supported over PCI Express for Intel Arria® 10 GX.
|Device Family||Board||Ethernet (FIL)||JTAG (FIL, AXI Master, Data Capture)||PCI Express (FIL)[a]||Comments|
Intel Arria II
|Arria II GX FPGA Development Kit||x||x|
Intel Arria V
|Arria V SoC Development Kit||x|
|Arria V Starter Kit||x||x|
Intel Arria 10
|Arria 10 SoC Development Kit||x||x|
|Arria 10 GX||x||x||x|
Quartus® Prime 18.0 is not recommended for Arria 10 GX over PCI Express®.
Intel Cyclone® IV
|Cyclone IV GX FPGA Development Kit||x||x|
|DE2-115 Development and Education Board||x||x||The Altera® DE2-115 FPGA development board has two Ethernet ports. FPGA-in-the-loop uses only Ethernet 0 port. Make sure that you connect your host computer with the Ethernet 0 port on the board via an Ethernet cable.|
Intel Cyclone III
|Cyclone III FPGA Starter Kit||x|
Altera Cyclone III boards are supported with Quartus II 13.1
Support for Cyclone III device family will be removed in a future release.
|Cyclone III FPGA Development Kit||x||x|
|Altera Nios II Embedded Evaluation Kit, Cyclone III Edition||x||x|
Intel Cyclone V
|Cyclone V GX FPGA Development Kit||x||x|
|Cyclone V SoC Development Kit||x|
|Cyclone V GT Development Kit||x||x||x|
|Terasic Atlas-SoC Kit / DE0-Nano SoC Kit||x|
|Arrow SoCKit Development Kit||x|
Intel Cyclone 10 LP
Altera Cyclone 10 LP Evaluation Kit
Intel Cyclone 10 GX
Altera Cyclone 10 GX FPGA Evaluation Kit
Must be used with Quartus Prime Pro
Intel MAX 10
Arrow MAX 10 DECA
Intel Stratix® IV
|Stratix IV GX FPGA Development Kit||x||x|
Intel Stratix V
|DSP Development Kit, Stratix V Edition||x||x||x|
[a] FIL over PCI Express connection is supported only for 64-bit Windows® operating systems.