Setup and Configuration
Simulink® Coder™ Support Package for NXP™ FRDM-KL25Z Board enables you to create and run Simulink models on the FDRM-KL25Z Board.
The support package enables you to:
Run Simulink models on the NXP FRDM-KL25Z Board using a GNU ARM based tool chain.
Access peripherals such as ADC, UART, Digital I/O, Line camera, Servo motor, DC motor with Simulink driver blocks for the NXP FRDM-KL25Z Board and the NXP FRDM-TFC shield.
Tune parameters and monitor signals in real-time using External mode.
Run models on the NXP FRDM-KL25Z Board in a multi-tasking fashion, enabling pre-emption of slower rate groups by faster rate groups and allowing external mode to run in a background task (or loop or nothing).
Verify the generated code using PIL with top model, referenced model, or the subsystem model if the Embedded Coder is installed with MATLAB®.
- Install Support for NXP FRDM-KL25Z Board
Install support for NXP FRDM-KL25Z Board.
- Install Drivers for NXP FRDM-KL25Z Board
The NXP FRDM-KL25Z board has an open standard embedded serial and debug adapter called OpenSDA.
- Connect TFC Shield to the NXP FRDM-KL25Z Board
Connect TFC Shield to the FRDM-KL25Z Board.
- Open Block Library for NXP FRDM-KL25Z Board
Open Block Library for NXP FRDM-KL25Z Board.
- Install OpenSDA Firmware on FRDM-KL25Z Board
Install OpenSDA Firmware on FRDM-KL25Z.