Main Content

Board-Specific Setup Information

Intel Arria 10 SoC development kit

To set up the board:

  1. Plug in the power cord, and then connect the host computer to the FPGA board by using a JTAG cable.

    Note

    For setting up the boards, you do not need an Ethernet cable or an SD card.

  2. Specify the SW3 switch settings.

    Bit 1Bit 2Bit 3Bit 4Bit 5Bit 6Bit 7Bit 8
    OffOnOnOnOnOffOffOff
  3. Connect two DDR4 plugin boards to the memory plugin slot.

This figure shows the configuration settings for the Intel® Arria® 10 SoC development kit.

To learn more about the board configuration, see the Arria 10 SoC Development Kit User Guide.