increasing value in stateflow

12 次查看（过去 30 天）
Luhur
Luhur 2011-7-11
评论： Antony Smith 2022-10-12
hi all
i want to make condition STATEFLOW, like:
*V=10 X=1 Z=20
if S>=5 && S<=10
then Value V repeatly increase by the value of X until its reach value Z.
so, the value V later could be= 11, 12, 13, 14, 15, 16, 17, 18, 19, 20 then go to next state after reach value Z=20.*
how we did it in stateflow??
thanks

请先登录，再回答此问题。

采纳的回答

Gerd
Gerd 2011-7-11
Hi Luhur,
assume you have 2 states. One is called increment the other is called nothing. With your S variable checked in a transition you can choose where to go.
Assume S satisfies the criteria and you are right now in state increment. In this state you can write EN:V = V + X; So everytime you enter this state V is incremented by X. From the state increment you can check in a transition if V>=Z and go to the next step.
If you are in state nothing you don't have to do anything just go back and check S again.
Gerd
  4 个评论
显示 2更早的评论
Luhur
Luhur 2011-7-12
the key is make a function in local stateflow to save data for a while. THANKS GERD!!!
Antony Smith
Antony Smith 2022-10-12
I thought it would be this simple but I am getting a very irritating error:
The data signal was read before being written to.
This error will stop the simulation. State 'variable_1' in Chart 'sens_mtr/Motor Controller/Chart':
signal = signal + 20;
The variable was already given an initial value in a previous block before reacing this block? Any ideas of what causes this?

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Complex Logic 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by