How can I overlay Simulink curves obtained when model parameters are changed?
3 次查看(过去 30 天)
显示 更早的评论
Hello: I want to be able to overlay simulink scope plot curves obtained from different model parameter settings.
For example, I can generate a step transient curve for an open loop system and a step transient curve for a closed loop system, but how do I overlay the two plots on the same axis for comparison purposes.
Is there something in simulink similar to the "hold on" function in Matlab so that curves can be overlayed on the same axis?
Thanks
1 个评论
Stefanie Hiu
2023-12-5
Hi did you ever find out how to do this? Because I am currently facing the same problem.
采纳的回答
Fangjun Jiang
2023-12-5
Not on the Scope block, but these days you can utilize the Simulink Data Inspector (SDI). Run simulation multiple times and then compare the same signal.
1 个评论
madhan ravi
2023-12-5
编辑:madhan ravi
2023-12-5
+1 and Answer Accepted Fangjun: yes, SDI makes life much easier and saves a lot of time to do MiL testing for example.
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 View and Analyze Simulation Results 的更多信息
产品
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!