SNR Calculation on the basis of channel estimation using Pilot Symbols

12 次查看（过去 30 天）
Rimsha Javed
Rimsha Javed 2025-1-14
回答： charan 2025-2-11
Hi,
I wanted to ask how can we calculate SNR on the basis of channel estimation using Pilot Symbols and make CQI table for Adaptive modulation coding according to the estiamted SNR values.
Regards
  2 个评论
Rimsha Javed
Rimsha Javed 2025-1-15
As per my understanding channel estimation alogrithms are implemented at RX side to find the impact of channel like Rayleigh channel on the Received signal. The recevied signal is coorelated with the known pilot signals to find the impact and then equalized to mitigate the chaneel impairments. To find noise , this estimated signals is subtracted from the known pilot signals. Then we find SNR by finding Singal Power and Noise Power, and then CQI table is formed on the basis of this SNR. which paramters should be in consideration while making CQI with SNR threshold.
Please correct me if my concept is wrong.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

charan
charan 2025-2-11
Hi,
Channel estimation is done at the receiver end using pilot signals and based on this estimation the CSI parameters like RI, CQI are calculated. A certain SNR level is mapped to a CQI value when the "BLER" (Block Error Rate) for the link is within acceptable range and the coding scheme is the maximum possible one. The following documentation gives more information about CQI mapping:
https://www.mathworks.com/help/5g/ug/5g-nr-downlink-csi-reporting.html#:~:text=beam%20combining%20coefficients.-,CQI%20Selection,-The%20CQI%20is

类别

在 Help Center 和 File Exchange 中查找有关 PHY Components 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by