Does MATLAB GUIDE GUI can work standalone when installed to Raspberry Pi using Simulink?

2 次查看（过去 30 天）
Marikit Avendaño
Marikit Avendaño 2018-1-30
评论： Walter Roberson 2020-10-21
I did an image processing program using Matlab Guide and I was looking online for answers if it is possible to run the GUI on the raspberry pi using Simulink. I am really new to Raspberry Pi and Matlab so I don't know if this will work or not. If it will not work, what alternatives do I have? Thank you very much.
  6 个评论
显示 4更早的评论
Haleh
Haleh 2020-10-21
Hi,
I want to follow up on the tread and see if the answer is still the same for MATLAB 2020b and Rasberry Pi 4 Model B?
I would appreacite your input on this.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Walter Roberson
Walter Roberson 2019-2-22
No, the interface to Raspberry Pi from Simulink only supports displaying image frames; there is no direct plotting support. All GUI elements would have to be drawn into image buffers using the Computer Vision toolbox tools such as insertText and insertShape. Callbacks and so on are not supported.
As of R2018b additional support was added to permit MATLAB Coder to deploy MATLAB code to Raspberry Pi. However, MATLAB Coder does not support GUI interfaces.

类别

在 Help Center 和 File Exchange 中查找有关 Run on Target Hardware 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by