Simulink model for DC shunt motor does not give correct output despite no errors.

3 次查看（过去 30 天）
Saiankita Anand
Saiankita Anand 2018-10-14
回答： Sabin 2024-12-24
The attached Simulink .mdl file (MATLAB 2017) contains a model for DC shunt motor. The DC motor block was cut and pasted from MATLAB 2014. The model runs but the output is not correct. Scope does not show plots for armature current vs speed, torque vs speed.
Help and suggestions appreciated.

请先登录，再回答此问题。

回答（1 个）

Sabin
Sabin 2024-12-24
This seems to be a parameterization issue. Increasing the field resistance to 150 Ohm will enable simulation to a nonzero speed. The exact parameterization will depend on application requirements.

社区

更多回答在  Power Electronics Control

类别

在 Help Center 和 File Exchange 中查找有关 Motor Drives 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by