How To Setup An External Trigger In Image Acquisition Toolbox for a Point Grey Grasshopper3

Question

Adil Khan 2019-6-11

1
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/466541-how-to-setup-an-external-trigger-in-image-acquisition-toolbox-for-a-point-grey-grasshopper3

评论： Ravi Umadi 2021-2-15

I have a Grasshopper3 GS3-U3-23S6M USB camera and I would like to trigger continuous recording with an external signal.

I am using MATLAB 9.6 (R2019a), the Image Acquisition Toolbox version 6.0 and the Image Acquisition Toolbox Support Package for Point Grey Hardware.

I have version 2.11.3.121 of Flycap, which came with the toolbox support package.

I have an Arduino set up to deliver an external signal to GPIO3

In matlab I set:

vio = videoinput('pointgrey', 1, 'F7_Mono12_1920x1200_Mode0');

triggerconfig(vio, 'hardware','risingEdge','externalTriggerMode15-Source3');

vio.FramesPerTrigger = Inf;

vio.TriggerRepeat = Inf;

src.TriggerParameter = 1024;

This works perfectly when setup using Flycap2, however when I use Matlab the camera does not start acquiring images when the external trigger is sent.

I have re-installed both flycap and the point grey image Acquisition Toolbox Support Package

I have tried both GPIO0 and 3 as external sources,

I have tried all trigger modes

2 个评论
显示无隐藏无

Faber Octavianus 2020-2-13

Hi,

I'm currently facing the similar problem in using Arduino for hardware triggering a point grey Grasshopper3 camera, have you found the solution to this and might want to share it? Thanks.

Ravi Umadi 2021-2-15