Why do I get an error about a missing target data map file, although I am using XCP external mode?
17 次查看(过去 30 天)
显示 更早的评论
MathWorks Support Team
2020-2-13
回答: MathWorks Support Team
2020-2-13
I am trying to run my application using XCP-based external mode. However, I see the following error message about a non-existing "model_targ_data_map" file when I try to connect to the target:
>> set_param(modelname, 'SimulationMode', 'external');
>> set_param(modelname, 'SimulationCommand', 'connect');
Could not execute target data map file 'myModel_myTarget_rtw\myModel_targ_data_map' or it does not exist.
Stop the target, delete the myModel executable, rebuild the code, and try again.
Note that execution of external mode requires the build directory to be present
采纳的回答
MathWorks Support Team
2020-2-13
XCP-based External Mode does not generate a target data map file. Therefore, we suspect that the the default setup of the External Mode transport layer was modified and the current values are incorrect.
Please type from the MATLAB console the following commands:
>> idx = get_param(modelName, 'ExtModeTransport')
>> cs = getActiveConfigSet(modelName)
>> [transport, mexfile, interface] = Simulink.ExtMode.Transports.getExtModeTransport(cs, idx)
In order to run XCP-based External Mode, you should see the following output:
>> [transport, mexfile, interface] = Simulink.ExtMode.Transports.getExtModeTransport(cs, idx)
transport =
'XCP on TCP/IP'
mexfile =
'ext_xcp'
interface =
'Level2 - Open'
0 个评论
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Multicore Processor Targets 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!