I want to use a comparator to compare a sine wave and a triangle wave in simscape. I can't get the components to connect.

Question

Steve Barry 2021-4-15

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/803326-i-want-to-use-a-comparator-to-compare-a-sine-wave-and-a-triangle-wave-in-simscape-i-can-t-get-the

回答： Joel Van Sickel 2021-4-20

I'm using Simscape electrical to design a control strategy for the switches in a dc/ac inverter, and I can't get the triangle wave generator to connect to the negative side of the comparator, even with the Simulink-PS Converter. Thank you in advance for any assistance you can provide.

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Steve Barry 2021-4-15

Also, what connects the output of a CMOS Not to the input of a PS-Simulink Converter? Thanks again.

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Joel Van Sickel 2021-4-20

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/803326-i-want-to-use-a-comparator-to-compare-a-sine-wave-and-a-triangle-wave-in-simscape-i-can-t-get-the#answer_680167

Unfortunately, the ps signal blocks don't work with those connection labels. Instead, you can make the switches take in electrical wires instead of physical signal blocks. The electrical wire does work with the connection labels. To do this, right click the switch, and find the simscape menu, go to block choices, and select electrical control port. Please see the image below.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

Answer 2

Joel Van Sickel 2021-4-19

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/803326-i-want-to-use-a-comparator-to-compare-a-sine-wave-and-a-triangle-wave-in-simscape-i-can-t-get-the#answer_678907

You need to use the Ps-Simulink converter, and then feed that signal into a controlled voltage source to interface with the elctrical comparator. Or, you can do everything in simulink and only bring out the gate signal once it is generated.

Regards,

Joel

3 个评论
显示 1更早的评论隐藏 1更早的评论

Joel Van Sickel 2021-4-19

If you stay in simulink, you can convert the boolean output back to a double and multiply it by whatever value you want. Can you provide a picture of what you are trying to do in Simscape?

Steve Barry 2021-4-20