Why is my Coreco image capture device, which uses IFC 5.8, not recognized by the Image Acquisition Toolbox 1.7 (R14SP1)?

2 次查看（过去 30 天）
MathWorks Support Team
I have installed a Coreco image capture device that uses IFC 5.8. According to the documentation, my card should be supported. When I run IMAQHWINFO, however, my hardware is not recognized. Why is this happening?

请先登录，再回答此问题。

采纳的回答

MathWorks Support Team
This bug has been fixed in Release 14 Service Pack 2 (R14SP2). For previous releases, please read below for any possible workarounds:
We have verified that there is a bug in the way that Image Acquisition Toolbox 1.7 (R14SP1) handles Coreco devices that use IFC 5.8. It is possible that reverting to IFC version 5.6.x will resolve this issue.
Alternatively, there is a patch available which adds support for IFC 5.8. Please note that this patch will only work for the Image Acquisition Toolbox 1.7 (R14SP1). The patch can be applied with the following steps:
1) Exit MATLAB
2) Rename the file mwcorecoimaq.dll to mwcorecoimaq.dll.old. This file is found in
$MATLAB\toolbox\imaq\imaqadaptors\win32
where $MATLAB is the root directory of your MATLAB installation.
3) Download the attached file mwcorecoimaq.dll and place it in the directory.
4) Start MATLAB.
5) From the command-prompt, execute the command
rehash toolboxcache

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Introduction to Installation and Licensing 的更多信息

标签

产品


版本

R14SP1

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by