HTS221 Humidity Sensor

The block outputs the relative humidity in percentage (%).

Dependencies

This output port appears only if you select the Humidity (%) parameter.

Data Types: double

Dependencies

This output port appears only if you select the Temperature (℃) parameter.

Data Types: double

Status of pressure and temperature measurements, specified as a 1-by-2 vector. 0 indicates that the data read is new, 1 indicates that the data read is not new, and -1 indicates that the corresponding output is not selected.

Dependencies

This output port appears only if you select the Status parameter.

Data Types: int8

Specify the I2C module on the board. The I2C bus frequency, serial clock (SCL) pin and serial data (SDA) pin are taken according to the corresponding I2C module entry in the configuration parameters.

Select this parameter to set Humidity as one of the output ports.

Select this parameter to set Temperature as one of the output ports.

Select this parameter to set Status as one of the output ports.

Select the output data rate at which humidity data is sampled.

Specify how often this block reads the data from the HTS221 sensor. When you set this parameter to -1, Simulink determines the best sample time for the block based on the block context within the model.