Generate Code and Deploy the Model to the Hardware

Generate Code and Deploy the Model to the Hardware

Step 7 of 7 in Create a Digital Write Block

In the Simulink^® Editor, select Simulation > Model Configuration Parameters.
In the Configuration Parameters dialog box, on the Hardware Implementation pane, set Hardware board to match your hardware, for example, 'Raspberry Pi'.
On the Hardware tab of the toolstrip, in the Mode section, select Run on board, and then click Monitor & Tune to build and run the model containing your System object™ on the hardware board.

While the model runs on the hardware, the LED blinks on and off in 1 second intervals.

See Also

Create a Digital Write Block | Create the MATLAB System Block | Create a Digital Read Block | Block Mask | Simulation with Device Driver Blocks | Sharing Device Driver Blocks with Other Users

Create a Digital Write Block