Matlab, Simulink, which block?

1 次查看（过去 30 天）
Mark Wood
Mark Wood 2013-11-15
编辑： Carla 2013-11-15
Hi, I've only been using Matlab for a week or so at Uni, so am a complete newbie. As part of my coursework I must create a PID closed-loop control system. The problem I have is; as part of a feedback loop to be created in simulink, the given circuit shows a block with the value (0.5). I've tried using (constant), but get red wires. It needs to have an input wire & output wire. What block should I be using?

请先登录，再回答此问题。

采纳的回答

Carla
Carla 2013-11-15
编辑：Carla 2013-11-15
Perhaps what you want is the Gain block, with the gain value set to 0.5. This takes an input and multiplies it by 0.5, to output the result.
The Constant block that you tried to use is a source; it doesn't have an input, just an output set to the constant value.
You might also find the PID Controller block of interest.

更多回答（1 个）

Umair Nadeem
Umair Nadeem 2013-11-15
编辑：Umair Nadeem 2013-11-15
I dont exactly understand what you are trying to say. If you are asking on how to implement a PID then I would say that you would need three blocks. First a constant for P(Proportional), second a derivative block for D and third an integral block for I. The outputs of all these blocks will get added and will connect to the system and provide the feedback. You can easily find these blocks in simulink.
If this doesn't answer your question then please elaborate, it will help.

类别

在 Help Center 和 File Exchange 中查找有关 Schedule Model Components 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by