Problem in linearizing a Simulink model
2 次查看(过去 30 天)
显示 更早的评论
I am trying to use linmod to extract a linear model of a non linear controller. I first trim the model in SIMULINK using the "trim" command, and receive correct results for my trim states ("xInitial") and model inputs ("FCS_Input") for a known output of the system. When I use linmod('mymodel',xInitial,FCS_Input) with "xInitial" & "FCS_Input" calculated by the trim function, I receive a "D" matrix that is identically zero. My model obviously has some linear i/o transmissions so that D must have some non-zero elements in it. Could the result I'm getting be due to direct connection of some of the inputs to terminator blocks? (I do this because the inputs to the model are vectors, where only part of the components are actualy used by my controller)
0 个评论
采纳的回答
Guy Rouleau
2013-12-6
编辑:Guy Rouleau
2013-12-6
It is difficult to say without looking inside the subsystem in your model.
A few tips: - If you have Simulink Control Design, there is a diagnostic window that can help you understand how each block is linearized and see which block is problematic.
- With linmod, the only tip I can give it to linearize pieces by pieces to see which block linearizes as zero.
0 个评论
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Linearization 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!