finding the length of a pendulum in motion
显示 更早的评论
When i write the following code, for count = 1:nFrames lab = bwlabel(seg_pend(:, :, count)); property = regionprops(lab, 'Centroid'); pend_centers(count, :) = property.Centroid; end i get an error of "too many outputs requested" how can i correct it?
采纳的回答
Brett Shoelson
2011-2-9
property = regionprops(lab,'Centroid') returns a struct, the fields of which correspond to each ROI (blob) in lab. To convert the centroids of those ROIs into a vector, you might consider something like:
b = reshape([property.Centroid],2,[])';
and then write them en masse to pend_centers.
Or, inside of your for loop, consider writing:
pend_centers(count,:) = property(count).Centroid;
Cheers,
Brett
更多回答（1 个）
Walter Roberson
2011-2-9
0 个投票
You shouldn't try to measure the length of a pendulum in motion. The bottom tip is moving so much faster than the anchor point that you need to take in to account relativistic contraction, but you can't, because you cannot simultaneously measure the position and the velocity (Heisenberg). It is thus advisable to instead wait until the pendulum reaches to top of its arch and thus has a velocity of 0, as you would not need any relativistic correction for the length then.
类别
在 帮助中心 和 File Exchange 中查找有关 ROI-Based Processing 的更多信息
2011-2-9
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
