signal builder: repeat a signal for n times in one simulation (not to be confused with running in succession)

Question

0 个投票

Hello,

is it possible to repeat signals of the signal builder periodically, so that it would be possible to run maybe 6 times cycle 1 and 1 times cycle 2 without building up ultra-long signals by hand? Running signals in succession is not what I am looking for, since the system changes from cycle to cycle (e.g. heating up).

Regards

Andreas

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Fangjun Jiang 2011-7-15

+1, Good question! I am bump it up to see if there is an easy way to generate a periodic signal in Signal Builder block.

请先登录，再进行评论。

请先登录，再回答此问题。

Follow Question

Answer 1

Mark 2011-7-19

0 个投票

I don't know of a good way to do this using "Signal Builder", but the "From Workspace" block allows you to specify repetition after all the data has been used once.

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Andreas 2014-12-15

Sometimes better to use than repeating sequence. Working crutch so far.

请先登录，再进行评论。

Answer 2

Doug Eastman 2011-7-19

0 个投票

Currently the only options for extending the signal beyond the time range in which it is defined in the Signal Builder block are Set to zero, Hold final value, or Extrapolate.

You could either use the From Workspace block or Inport block to pull in data directly from MATLAB or you could programatically build your Signal Builder block using the SIGNALBUILDER function.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

Answer 3

Fangjun Jiang 2011-7-19

0 个投票

It sounds like that currently Signal Builder block can't do that. The Repeating Sequence block from Source library can easily do this. I think Signal Builder block needs to be expanded to have this capability. Imaging that all your signals are built into groups, this inconvenience prevents your from press that "run all" button.