Matlab surface isolines

Question

Chris 2011-7-20

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/12037-matlab-surface-isolines

Hi, I have a triangular surface that I'm plotting using the trimesh() function. Each node of my mesh has a value that I am representing using the figure colorscale. What I would like to do is add "isolines" to the surface so you can get a better since of the data. However, when I try using plot3() to plot these lines on top of the surface, most of them are not visible. Does anyone know how I can plot visible lines on top of a surface in matlab?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Sean de Wolski 2011-7-20

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/12037-matlab-surface-isolines#answer_16482

在 MATLAB Online 中打开

EDIT per comments:

Of course; set the facealpha property of the mesh to a small number (1 is opaque, 0 is transparent). This will allow your line to be visible:

[x,y]=meshgrid(1:15,1:15);  %ml example from doc
tri = delaunay(x,y);
z = peaks(15);
trimesh(tri,x,y,z,'facealpha',0.2)
hold on
plot3([1 30],[1 30],[0 pi])

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Chris 2011-7-20

Unfortunately, using line() instead of plot3() gives the same behavior. If I create a small pyramid using trimesh() and test either of these commands with a sample line, the line ends up being visible only where it does not overlap with one of the triangle faces.

请先登录，再进行评论。