Using loops for simulation in Simulink
1 次查看(过去 30 天)
显示 更早的评论
Hello
I have a Simulink model that does arithmetic to calculate value "B". I would like to make use of this value "B" and subtract it from the initial value "A" used in the model. I would like to then use this new calculated value of "A" to do rest of the simulation. When I try to do this by connecting the blocks, I get an error message saying:
"Simulink cannot solve the algebraic loop containing 'Combined/Angle Calculation' at time 0.01 using the TrustRegion-based algorithm due to one of the following reasons: the model is ill-defined i.e., the system equations do not have a solution; or the nonlinear equation solver failed to converge due to numerical issues. To rule out solver convergence as the cause of this error, either a) switch to LineSearch-based algorithm using set_param('Combined','AlgebraicLoopSolver','LineSearch') b) reducing the ode45 solver RelTol parameter so that the solver takes smaller time steps. If the error persists in spite of the above changes, then the model is likely ill-defined and requires modification."
Please help
0 个评论
采纳的回答
Azzi Abdelmalek
2014-3-24
add a unit delay block to your simulink model just after the calculation of A, you can set the initial value of this block.
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Simulink Functions 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!