How can I use an Op Amp with models from SimPowerSystems and integrate the circuit?
显示 更早的评论
I am working on a compensation based buck converter design which needs simulations. I need to use SimPowerSystems blocks like RLC element, Power Mosfet, Power Diode. Additionally I need to use an Op Amp which is not a SimPowerSystems blockset. I do not need to isolate this circuit because the Power Electronics components are not going to be operated at high voltages. I am intending this for low voltage applications (~ 5V ) hence there should be no issues with the Op Amp voltage wise.
采纳的回答
A Jenkins
2014-4-30
0 个投票
4 个评论
Abe
2014-5-1
A Jenkins
2014-5-1
Unfortunately I didn't save it, but the components are labeled so you should be able to recreate it pretty quickly by searching the library.
Abe
2014-5-1
Yes I did do that. I am currently stuck here (photo attached). How do I make the power electronic part of the circuit drive the simscape part. Kinda the opposite of what you have done above. As you can see I used the S-PS converter but I don't know why it wont connect. What am I doing wrong here?
A Jenkins
2014-5-2
You are missing the Controlled Voltage Source after the S-PS Converter.
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Simscape Electrical 的更多信息
Translated by 
