how to detect point before it went on plateau

3 次查看（过去 30 天）
Sharah
Sharah 2014-6-16
回答： Star Strider 2014-6-16
Hello everyone, I am new to matlab and I am doing a force analysis. I would like to detect a point in matlab before it went on a plateau, for example, this picture below (taken from a journal)
but from my graph, i can only able to detect the peak point, not the plateau, example below
(top picture) i am not sure how to find the minimum point of plateau (green line graph) and the point until it start to go down again, and then plot a line through it, as well as label each point (tp, tr, tf). will somebody help me on this?
attached is my data for 3 forces and time.
  2 个评论
Image Analyst
Image Analyst 2014-6-16
What is the algorithm described in the paper? Can't you just use the same method they did?
Sharah
Sharah 2014-6-16
i don't think they use any specific algorithm, they just detect the point befre and after the plateau.

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Star Strider
Star Strider 2014-6-16
It looks as though the ‘LC Green’ signal is what you want. You might have to filter it first to eliminate the noise, but then I would take its derivative and test for the derivative being close to zero. That should approximately define the start and end points of the plateau.

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Descriptive Statistics 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by