How to change FFT settings ?
显示 更早的评论
I am analyzing a power system simulated on SIMULINK for which I need to use some FFT tool. Usually, the "Powergui" is used to get the FFT of a signal. However, when I use it I do not get specific frequencies that are present in the signal. The results display all the frequencies depending on the number of cycles I select and the frequency. Also, when I use the "power_fftscope" function, the fundamental frequency has been preset to 60 Hz; I want to change it to 50 Hz. Could you guys help me out in atleast one of the two problems mentioned above?
采纳的回答
Rashmil Dahanayake
2014-6-26
0 个投票
Are you using the Gui of the fftscope.
If so you can update the number of cycles and frequency as required. If you need only integet multiples of the fundamental, set number of cycles to 1.
In command line you, need to initially store fft results to a structure then modify the parameters(fundamental, cycles) prior to the second run.
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Spectral Analysis 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
