I recommend you to use the Filter Design and Analysis Tool. It is very easy to use, intuitive and you can generate the corresponding code to use it where you want. Just type
fdatool
EDIT In this case, you would have to choose the following:
* Response Type: Lowpass
- Explanation: Obvious
* Design Method: IIR Chebyshev Type I
- Explanation: Obvious
* Filter Order: 8
- Explanation: Obvious
* Frequency specifications
+ Units: Hz
- Explanation: Easier to visualize and understand
+ Sampling frequency (Fs): 125
- Explanation: Obvious
+ Pass Frequency: 49.350359831403956 (IMPORTANT: always try to use as many decimals as possible. You would be amazed at how these can make a difference).
- Explanation: In MATLAB you define a Chebyshev I LPF in function of its pass frequency Fp (and NOT in function of its cut off frequency Fc). Fortunately, there is a way to calculate Fp from Fc, which is as follows:
fp = fc / (cosh((acosh(1/(sqrt((10^(0.1*Apass))-1))))/N));
Where:
fc = Cut off frequency
Apass = Ripple in the pass band (in dB)
N = Order
* Magnitude specifications
+ Units: dB
- Explanation: Easier to visualize and understand
+ Apass: 1
- Explanation: This parameter refers to the amplitude of the pass band ripple (remember every Chebyshev Type I filter has ripple in the pass band). Normally I would recommend a much smaller value (0.1, 0.01, etc.). However, we will leave this case as 1 to make the ripple more evident.
Clic on "Design Filter". You will see the magnitude response, which matches with the desired filter behavior. If you want more information about Chebyshev (and other) filters, I recommend you this link. Even though it talks about analogue filters, most of the concepts apply to digital filters. You will find in it information that you would not find in any other place, including books (believe, I have consulted a lot of them).
This is the easy way. If you want, you can generate the filter from scratch code. However... That is a complete new story :-P.
