Simulink : Arduino serial receive 1 byte to control pin13 led ON/OFF

2 次查看（过去 30 天）
nt
nt 2014-7-7
评论： nt 2014-12-27
hi everyone:
Forgive my poor English :)
i first met Simulink these days.and i played all examples in it.
i want arduino can do things below in Simulink;i don't know how to setup up serial receive block.
can someone teach me a little bit :)
-------------------------------
void setup() {
pinMode(13, OUTPUT);
Serial.begin(115200);
}
void loop() {
while(Serial.available() )
if(Serial.read() == '1')
digitalWrite(13, HIGH);
if(Serial.read() == '2')
digitalWrite(13, LOW);
}

请先登录，再回答此问题。

采纳的回答

Sreeram
Sreeram 2014-7-31

更多回答（1 个）

Sreeram
Sreeram 2014-7-31
Hi nt,
The easiest way to get to what you want is to add a Serial Receive block and add a comparator or a switch case block as you seem good for your logic at the output of the block to decide and then glow and LED.
I have attached a simple model snapshot that shows how to achieve a simple case !
Hope this helps
Thanks,
Sreeram Mohan

类别

在 Help Center 和 File Exchange 中查找有关 Device Driver Blocks 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by