Accumulator providing flow even when system pressure is sufficiently above preload pressure.

1 次查看（过去 30 天）
Himanshu
Himanshu 2014-7-11
回答： Sebastian Castro 2015-12-8
I have connected pump to actuator via accumulator using SimHydraulics. I want accumulator to provide flow only when pump cannot meet the demand. As of now accumulator provides flow every time actuator demands and then gets recharged from pump. How can I avoid this flow from accumulator?

请先登录，再回答此问题。

回答（1 个）

Sebastian Castro
Sebastian Castro 2015-12-8
My understanding is that an accumulator connected directly to a system will still have some flow. A typical way to have more control over the accumulator is to implement a dump valve.
You put a check valve to the accumulator such that fluid can only enter the accumulator when the pressure is higher than accumulator + cracking pressure of the check valve, but not the other way around.
For the reverse case, when you want to discharge the accumulator, use a valve (variable-area orifice block) in parallel. Open the orifice to allow flow from the accumulator to the rest of the system based on some logic. This logic would be "when the actuator cannot sufficiently meet the demand".
- Sebastian

类别

在 Help Center 和 File Exchange 中查找有关 Upgrading Hydraulic Models to Use Isothermal Liquid Blocks 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by