Change specific simulation time in Simulink

3 次查看（过去 30 天）
Kelvin
Kelvin 2014-7-13
评论： Omar Al-Khatib 2021-1-22
Hello,
I have been working on a simulink model and the simulation works perfectly.
I wanna add a new block to the simulation, which only runs for a specific time. So lets say I run the simulation for 10000s, I only want the new block to run from 2000-4000.
Is this possible? And is there a way I can make a specific block start after some seconds?
Your Sincerly

请先登录，再回答此问题。

回答（1 个）

Azzi Abdelmalek
Azzi Abdelmalek 2014-7-13
You can use the block If-Then-Else Blocks
  5 个评论
显示 3更早的评论
Azzi Abdelmalek
Azzi Abdelmalek 2014-7-13
When there is no disturbance signal, we can consider it as equal to zero. Instead of telling: I will run a disturbance from 1000 to 2000, just set your disturbance signal to zero wherever you want

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Simulink 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by