Serial Communications: Simulink and Arduino interface

1 次查看(过去 30 天)
Hi,
I'm using an Arduino UNO (and later on, possibly a Mega) to process gyro and accel information from two IMU's. It's reading well but I'm having a tough time sending the sensor information to Simulink.
On my Arduino, I'm sending the data through the serial port via Serial.print(). It would end up looking like this:
...
21.60,-0.35,2.38,-13.92,-9.30,-79.69
21.52,-0.38,2.40,-16.48,-10.06,-78.18
21.44,-0.40,2.41,-19.00,-10.81,-76.57
21.36,-0.42,2.42,-21.47,-11.55,-74.90
21.28,-0.44,2.42,-23.86,-12.27,-73.20
...
I can read it fine through Arduino IDE but I'm kinda stuck as to how to port it to Simulink.
  1 个评论
prasad noolu
prasad noolu 2017-9-23
https://in.mathworks.com/matlabcentral/answers/270895-arduino-simulink-serial-communication this link might help

请先登录,再进行评论。

回答(0 个)

类别

Help CenterFile Exchange 中查找有关 Arduino Hardware 的更多信息

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by