can i run and directly modify a simulink model on a beaglebone black that is connected via wifi?

Question

cartman 2014-9-11

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/154368-can-i-run-and-directly-modify-a-simulink-model-on-a-beaglebone-black-that-is-connected-via-wifi

回答： Murat Belge 2014-11-19

I have the model in simulink and also I have configured the wifi adapter (in this case I use the interface that has the BEAGLEBONE board for setup ip fo the communication). It is possible that I can run the model simulik directly from matlab without having to intervene in linux interface, ie, if I change a value to model simulink real time, BEAGLEBONE board recive the data and runs it, for example, ordered to move an actuator?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Hong Ye 2014-10-29

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/154368-can-i-run-and-directly-modify-a-simulink-model-on-a-beaglebone-black-that-is-connected-via-wifi#answer_157014

it is possible to run the model in external mode and tune the parameter (assume it is tunable in your Simulink model) at run-time.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

Answer 2

Murat Belge 2014-11-19

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/154368-can-i-run-and-directly-modify-a-simulink-model-on-a-beaglebone-black-that-is-connected-via-wifi#answer_159520

Assuming you have installed the Embedded Coder Support Package for BeagleBone Black hardware, yes. Simulink requires a TCP/IP connection to run a model on BeagleBone Black hardware. Wired or wireless does not make a difference.