can i run and directly modify a simulink model on a beaglebone black that is connected via wifi?

1 次查看（过去 30 天）
cartman
cartman 2014-9-11
回答： Murat Belge 2014-11-19
I have the model in simulink and also I have configured the wifi adapter (in this case I use the interface that has the BEAGLEBONE board for setup ip fo the communication). It is possible that I can run the model simulik directly from matlab without having to intervene in linux interface, ie, if I change a value to model simulink real time, BEAGLEBONE board recive the data and runs it, for example, ordered to move an actuator?

请先登录，再回答此问题。

回答（2 个）

Hong Ye
Hong Ye 2014-10-29
it is possible to run the model in external mode and tune the parameter (assume it is tunable in your Simulink model) at run-time.
Murat Belge
Murat Belge 2014-11-19
Assuming you have installed the Embedded Coder Support Package for BeagleBone Black hardware, yes. Simulink requires a TCP/IP connection to run a model on BeagleBone Black hardware. Wired or wireless does not make a difference.

类别

在 Help Center 和 File Exchange 中查找有关 BeagleBone Black 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by