using neural network in Simulink
4 次查看(过去 30 天)
显示 更早的评论
Hi,
I have trained a neural network using LSTM method for sequence classification and load it in Simulink blocks "stateful classify", "predict", "classify", and expect a category number for the outcome of the blocks when I apply same-type sequences, but I get only a decimal between 0 and 1 instead, as shown in below pic:
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/795069/image.png)
any idea what is wrong with the blocks I am using? I was going to attach the Simulink model and workspace data related to the trained neural network model and input time series required to run the Simulink model but they were over size limit. will appreciate your response.
With Regards
0 个评论
采纳的回答
David Willingham
2021-11-9
Hi,
Are you asking why the "Predict" block is acting differently than the "Stateful Predict" block? IF so, are you specifying the same model in each?
If so, these block behave differently. The main difference is that if you are using a trained network with at least one recurrent layer (for example, an LSTM network), then Stateful predict is the block to use.
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Deep Learning Toolbox 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!