Simulink CANopen Blockset/ interface

44 次查看（过去 30 天）
Lukas Matias
Lukas Matias 2021-11-22
回答： Dimitri MANKOV 2021-11-22
Hi there,
similar to this thread, I need to control a motor via the CANopen protocol (unfortunately I don't really have any relevant experience with CANopen). As it still seems not be properly resolved, I thought I would post another question to draw some attention to this issue. I basically have a Simulink Real Time lab set-up, but from what I understand from the Simulink documentiation this would only allow me to communicate via CAN/ CAN-FD and J1939.
The question now is how to link Simulink and CANopen. As I understand it, to integrate the open-source implementation would be very time consuming and commercial solutions are not really an option (but I am still open to suggestions to consider). I found CANopen <-> J1939 converters (as Simulink Real-time and the Vehicle Network toolbox support J1939), might that be a practical solution? ...But am pretty much out of ideas otherwise.
Any help would be greatly appreciated!
Lukas

请先登录，再回答此问题。

采纳的回答

Dimitri MANKOV
Dimitri MANKOV 2021-11-22
Hi Lukas,
I see you are working with Simulink Real-Time. For this use case, I think the most appropriate way would be to look into CANopen I/O modules from Speedgoat. You can find more information here:
https://www.speedgoat.com/products-services/communications-protocols/canopen
Best,
Dimitri

更多回答（1 个）

Diego Kuratli
Diego Kuratli 2021-11-22
Speedgoat offers dedicated I/O modules enabling CANopen communication for Simulink Real-Time:
https://www.speedgoat.com/products-services/communications-protocols/canopen

类别

在 Help Center 和 File Exchange 中查找有关 Vehicle Network Toolbox 的更多信息

标签

产品


版本

R2021b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by