How do I stop my app from closing after messages are displayed?
4 次查看(过去 30 天)
显示 更早的评论
I am in the process of developing my first MATLAB app and decided to try the application compiler.
I've now installed my app, leaving just a few disp lines without a semicolon.
When I run it, the Windows command prompt closes immediately after my messages are shown.
What do I have to code to avoid this from happening?
0 个评论
回答(1 个)
Asim
2023-9-30
Hello @Mário Sousa
I understand that your compiled MATLAB application closes after displaying the contents whereas you want the application to stay open until you close it manually.
You can accomplish this by enclosing your code within a while loop. This loop will maintain your application in an active state until a certain condition which is defined by you is fulfilled.
I hope this suggestion helps in solving the issue you were facing.
Thanks,
Asim Asrar
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Introduction to Installation and Licensing 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!