How to find steady-error value from the response graph? is there any command to find the steady state error from the response graph?

206 次查看(过去 30 天)
G(s)=5/s^2+2s+25
  1 个评论
SARATHRAJ V
SARATHRAJ V 2022-2-13
s = tf('s');
sys=input('enter the funtion' );
Unable to run the 'fevalJSON' function because it calls the 'input' function, which is not supported for this product offering.
[y,t]=step(sys);
y(length(y))
plot(t,y);
xlabel('Time (sec)');
ylabel('Amplitude');
title('step responce');

请先登录,再进行评论。

回答(4 个)

Arkadiy Turevskiy
Arkadiy Turevskiy 2014-11-26
编辑:Arkadiy Turevskiy 2014-11-26
Your question is not formulated clearly. Did you mean steady-state value, not "steady-error value"? Assuming that's what you meant, the next clarification is steady-state value of a transfer function in response to what - is it in response to a step input?
If that's what you meant, then yes, you can do this like that:
>> s=tf('s');
>> sys=5/(s^2+2*s+25);
>> [y,t]=step(sys);
>> y(length(y))
ans =
0.20
You can also right click on a step plot, "Charecteristics", "Steady-state", as shown below:
  4 个评论

请先登录,再进行评论。


Miswar Syed
Miswar Syed 2020-4-8
SP=5; %input value, if you put 1 then is the same as step(sys)
[y,t]=step(SP*sys); %get the response of the system to a step with amplitude SP
sserror=abs(SP-y(end)) %get the steady state error
  3 个评论

请先登录,再进行评论。


Ur rehman Waheed
Ur rehman Waheed 2020-4-16
matlab command to find steadt state error from step response graph in matlab
>> sserror=(SP-(y1.data(end,end)))
where SP value is one when input is step input. y1 shows workspace value of step response. normally it comes during simulation from simulink.

Amit Borole
Amit Borole 2019-11-1
i need to find position constant of this

类别

Help CenterFile Exchange 中查找有关 Time and Frequency Domain Analysis 的更多信息

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by