How can I use multimeter in the sequential circuit design with Xor gate and measure power in microwatts?
1 次查看(过去 30 天)
显示 更早的评论
I am designing a sequential circuit using XOR gate in matlab2014 but when I ran the following errors occurs:
1. Invalid setting for input port dimensions of 'AHpower/Demux'. The dimensions are being set to [-1]. This is not valid because the total number of input and output elements are not the same. Component: Simulink | Category: Block error
2. Error in port widths or dimensions. Invalid dimension has been specified for output port 1 of 'AHpower/Multimeter'. Component: Simulink | Category: Block error How can I solve these errors?
1 个评论
Joel Van Sickel
2023-10-13
can you share your model? It probably has to do with how the multi-meter is set up and I can't tell just from the screenshot.
回答(0 个)
社区
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Simscape Electrical 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!