Disable code generation while runnign the simulation of a model

9 次查看（过去 30 天）
Sandeep
Sandeep 2014-11-28
评论： Sandeep 2014-11-28
I need to disable the code generation while running the simulation. I am using the below code with the parameters
set_param(TestModelName, 'SimulationMode', 'Software-in-the-Loop (SIL)');
set_param(TestModelName, 'GenCodeOnly', 'off');
sim(TestModelName)
But even then the code is generated. Any idea what else I can do to not generate the code.

请先登录，再回答此问题。

回答（1 个）

Orion
Orion 2014-11-28
If you want to simulate in SIL mode, SImulink will generate some code.
if you don't want any code generation, you need to set 'SimulationMode' to normal.
Note that if there are some stateflows in your model, some code will still be generating.
  1 个评论
Sandeep
Sandeep 2014-11-28
Agreed, on normal mode it wont generate any code. But my requirement is to run in SIL mode but not to generate any code. I want to use the previously generated code hence. This will also save considerably lot of time when I run for 98 models.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Programmatic Model Editing 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by