How can I assign values to my whole cell array? I am getting [], but am unsure as to why.

4 次查看（过去 30 天）
Sean Goulding
Sean Goulding 2022-2-24
评论： Sean Goulding 2022-2-24
I want my code to assign epochs (in 'a' datapoint intervals) into a cell array. In this case 'a' is 200. Total recording length is 587 epochs. 'k' is my patient number. Therefore, in this use case I should have a cell array with 46x587 cells, where each cell contains a 21x200 double. My code can be seen below:
for k = 1:46
for i = 1:b
NC_x{k, i} = NC_patient{k}(:,a*(i-1)+1:a);
end
end
Unfortunately, only the first column of my cell array is assigned the 21x200 doubles. Why is this, and how can I resolve it?
I look forward to receiving a response.
Kindest regards,
Sean
  2 个评论
the cyclist
the cyclist 2022-2-24
It's a bit difficult to know what the problem is. You don't mention what the value of b is. Could it be 1, and therefore you are only operating on the first column, in the loop over i?
Can you upload the data in a MAT file, so we can run your code?
Sean Goulding
Sean Goulding 2022-2-24
Assume b is greater than 1. In this instance it is 587. The code is pretty long, this is just one section of it. I was just wondering if there was any obvious reason why variables past the first column aren't being assigned cells.

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Walter Roberson
Walter Roberson 2022-2-24
for k = 1:46
for i = 1:b
NC_x{k, i} = NC_patient{k}(:,a*(i-1)+1:a*i);
end
end

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Get Started with MATLAB 的更多信息

标签

产品


版本

R2019a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by