SIMULINK Action subsystem with 1D-lookup Table, which data is not always available

Question

Bettina 2014-12-9

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/166010-simulink-action-subsystem-with-1d-lookup-table-which-data-is-not-always-available

评论： Bettina 2014-12-10

采纳的回答： Orion

在 MATLAB Online 中打开

Hello everybody,

I have question regarding Simulink subsystems, look-up tables and size mismachtes:

In my model I have two subsystems, which are controlled via a if-block. So subsystem number one is activated, if I have one type of aggregat, subsystem two, if I have another aggregat. Inside each subsystems I use the interp1 command in a MatLab Function block.

My problem is, that if on type of aggreagt activates one subsystem, the input data for interp1 look-up-table in the second subsystem is X=0,Y=0. So I get the error message: "There should be at least two data points."

But if I try this:

if size(X,1)==1                                                                        
    X=[X X+1];
    Y=[Y Y];
end
Data=interp1(X,Y,xi);

I get the error message "size mismatch (size[1x1]~=size[1x2]).

Anybody a idea or tipss how to solve this? Thanks!

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Orion 2014-12-9

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/166010-simulink-action-subsystem-with-1d-lookup-table-which-data-is-not-always-available#answer_161791

Hi,

First, why don't you use a look-up table block instead of a matlab function ?

Second, are you sure of the values of X and Y when the error occured ? You can profit the use of a matlab function by putting a breakpoint at the line Data=interp1(X,Y,xi);. This way the simulation will pause every time you arrive there, and you can check the values of all your variables inside the command window.

3 个评论
显示 1更早的评论隐藏 1更早的评论

Orion 2014-12-9

在 MATLAB Online 中打开

I wasn't paying attention.

The error occured because you redefined the inputs X and Y. It works In Matlab, but this is not working in Simulink, because Simulink need to calculate the size of the I/O signals, and here, it can't be done.

One way to solve your issue :

if size(X,1)==1                                                                        
    Abs = [X X+1];
    Ord = [Y Y];
else
    Abs = X;
    Ord = Y;   
end
Data=interp1(Abs,Ord,xi);