How to build constant power load in simulink?

32 次查看（过去 30 天）
xu qianwen
xu qianwen 2014-12-14
评论： Kamilu Sanusi 2023-4-21
I want to build a constant power load in simulink and I use controlled current I=P/Vdc, as shown in figure. But the result is wrong. The output voltge is very large because of the dclink capacitor. I don't know how to modify. As I have to do the simulation for step change of constant power load to see the result, I cannot use the series load block.

请先登录，再回答此问题。

回答（3 个）

Shashank
Shashank 2015-3-2
Hi...may be you can try using a 3 phase dynamic load block----set the required P and Q which will be equal to the initial Po and Qo since they do not change in time. Set the exponents np = 0 and nq =0 and all time constants as zero----if you want a 1 phase load out of it, try connecting all three input ports of 3 phase dynamic load block by a high value 3 phase parallel Resistor and connect only one port to the concerned phase.
  1 个评论
Shashank
Shashank 2015-3-2
Then connect the measurements output to a demux....then add a divide block to do P/V and give this as input signal to a controlled current source....

请先登录，再进行评论。

Shashank
Shashank 2015-3-3
PFA
Pawan
Pawan 2015-5-26
Single phase dynamic load can be found in example: "power_1phdynamicload" and you can set it as const. PQ, I ,Z by setting 0,1 and 2 resp.
  2 个评论
abde amar
abde amar 2017-2-1
Hello,
In Matlab/Simulink 2013, single phase dynamic load does not exist as block to use it.
Is there any version included that block?
Thank you
Kamilu Sanusi
Kamilu Sanusi 2023-4-21
@Shashank,@xu qianwen,@abde amar Please do you have an idea on i can model three phase PQ load? Please your assistance would be highly appreciated.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Switches and Breakers 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by