Build errors with Simulink CAN Transmit block on Raspberry Pi with CAN_MESSAGE as input
13 次查看(过去 30 天)
显示 更早的评论
Hello,
I have a problem with the CAN-Transmit block from the Raspberry Pi Simulink hardware support package. If I put a CAN Pack block in front of the Transmit block and set the input datatype to CAN_MSG for the Transmit block, I get the following error message during the build process:
The data type of input port 1 is 'CAN_MESSAGE'. MATLAB System block 'CAN Transmit' only supports built-in, binary point scaling [Slope=1.0, Bias=0.0], Simulink enumeration, and bus data types.
Tested with Simulink 2021b and 2022a.
Does anyone have the same problem or a solution for me?
1 个评论
回答(1 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Run on Target Hardware 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!