Is ir possible to use more than one reference signals when using looptune in MATLABR2012a?

2 次查看（过去 30 天）
Kah Wei
Kah Wei 2014-12-25
编辑： Kah Wei 2014-12-31
Hello everyone.I have a question here.
Currently I am trying to use sl.looptune to tune the parameters of my PID controller.The system that I am investigating is a 3 by 3 system as shown in the attached simulink model.
Tracking requirement is the objective that I wish to achieve by using sl.looptune. However I encounter an error that says:
"Zero or more than one input signals match the reference signal identifier "R1"."
Does that mean I only can use one reference signal for the system when applying tuning requirement in sl.looptune for my 3 by 3 system?
  2 个评论
Kah Wei
Kah Wei 2014-12-30
Hi Arkadiy.Thanks for taking time to answer.I already attached the script in this question as requested.
Ther version of MATLAB that I am using is MATLAB Version: 7.14.0.739 (R2012a)

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Arkadiy Turevskiy
Arkadiy Turevskiy 2014-12-30
编辑：Arkadiy Turevskiy 2014-12-30
Ok, with the script provided, the problem is obvious. The script is referring to signals u1, u2,u3, and y1,y2,y3 in the model, but they are not defined there. All you need to do is name those signals in the model, as is done in the attached file.
Change your script to refer to this mdl file in lines 19 and 22.
I ran your script to line 49 and ran the model with the tuned gains to confirm a nice, stable design.
Arkadiy
P.S. If you have access to R2014a or R2014b, you can now do this workflow from a nice app (GUI) called Control System Tuner - makes it easier to setup the problem and not screw up the code.
Check it out here .

更多回答（1 个）

Arkadiy Turevskiy
Arkadiy Turevskiy 2014-12-29
Most likely you need to specify signals of interest as I/O points, and then this problem would go away.
I.e., before you refer to R1 in something like TuningGoal.Tracking, define it as an input IO point:
ST0.addIO({'R1','R2','R3'},'input') % setpoint commands
  1 个评论
Kah Wei
Kah Wei 2014-12-30
I already proceed to define R and Y as my inputs and outputs respectively and yet I still encounter the error as shown below:
Zero or more than one output signals match the tracking signal identifier "y1"
I still cant figure out what is the problem....

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Loop-Shaping Design 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by