UDP communication Raspberry pi with direct Ethernet connection

Question

Waleed El-Badry 2015-1-4

1
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/168919-udp-communication-raspberry-pi-with-direct-ethernet-connection

评论： vcmorini 2017-2-22

Hi, I recently downloaded and installed Raspberry Pi package (Simulink+MATLAB) and chose direct PC connection.

I tested the sine wave model (External mode) and it worked just fine. I even tested it by removing ethernet cable and reconnecting it and it was disconnecting and resuming on the plot. Also pinging the IP of raspberry pi is success.

The problem is when applying UDP communication example, I receive nothing. I made sure that Normal mode is selected and then deploying the on hardware . I tested when assigning my host IP and another time with '255.255.255.255' (Broadcast). Both got me nothing when running host communication model.

Here is the example Communicating with Raspberry Pi Hardware

My question is, is it possible to receive UDP packets from Raspberry Pi if Direct connection is selected? Hope someone could assist me.

Thanks in advance. I use Model B.

2 个评论
显示无隐藏无

sandeep rathore 2015-1-24

hii Waleed El-Badry, I am using matlab 2013a and raspberry pi model B. but whenever i try to install Raspbian Wheezy image from support package it gives error like this "firmware error.wait a couples of minutes and try again" give me some suggestion to solve it.

vcmorini 2017-2-22