Error when connecting output of SR Flipflop to Byte Pack of desktoptargetslib
9 次查看(过去 30 天)
显示 更早的评论
I am trying to use Byte Pack block in Simulink to pack data for UDP Transmission. However, when the input of Byte Pack is the output Q of an SR Flipflop, I see below compile errors. Not sure how to solve this.
Error reported by S-function 'any2byte' in 'Signal_Interface/Byte Packing10/Byte Pack': backward propagation not supported
Component: Simulink | Category: Model error
Error in port widths or dimensions. 'Input Port 1' of 'Signal_Interface/Byte Packing10/Demux' is a one dimensional vector with 8 elements.
Component: Simulink | Category: Model error
2 个评论
回答(1 个)
Narvik
2023-12-28
编辑:Narvik
2023-12-29
Hi,
As per my understanding, while trying to compile a Simulink model, you are receiving the following errors:
- Backward propagation not supported
- Error in port widths or dimensions
These errors occur when the signal attributes (data type, dimension, etc.) are backpropagated from the input port of the Byte Pack block to the source block. Refer to the following MATLAB answer for more information on the issues and resolution steps:
Hope this helps!
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 General Applications 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!