I want to continue sending data to Thing Speak using the Arduino MKR WiFi 1010

6 次查看（过去 30 天）
seiya moro
seiya moro 2022-4-20
编辑： Christopher Stapels 2022-4-21
Currently, I am trying to send GPS sensor data to ThingSpeak in real time.
I made the Arduino MKR WiFi 1010 build, distribute and start the program. Then, the data is sent to ThingSpeak only once at the moment when the plug ram is inserted, but the data is not sent after that.
Is there a solution?
Thank you very much!
  4 个评论
显示 2更早的评论
Christopher Stapels
Christopher Stapels 2022-4-20
编辑：Christopher Stapels 2022-4-21
Do you have a paid ThingSpeak license? A paid license is required for updates at 1 second.
I would set the update time slower (20 seconds perhaps) at the start just to be cautious, and increase it later.
What do you mean by "when the monitoring and adjustment is performed." Have you been able to successfully delpoy previously?
I would focus on the simulation more (hardware in the loop) and make sure you can get the ThingSpeak part working there first. You might even try another model with just the ThingSpeak block hoocked up to a constant to help you troubleshoot.
seiya moro
seiya moro 2022-4-20
I have a license.
I would like to try it once, in 20 seconds.
'when the monitoring and adjustment is performed' is the button circled in red.
I would like to check this with other, constant values.
Thank you very much!

请先登录，再进行评论。

请先登录，再回答此问题。

回答（0 个）

社区

更多回答在  ThingSpeak Community

类别

在 Help Center 和 File Exchange 中查找有关 Run on Target Hardware 的更多信息

标签

产品


版本

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by