Need help in converting this subsystem to model

Question

Saurabh Sakpal 2015-1-15

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/170043-need-help-in-converting-this-subsystem-to-model

关闭： MATLAB Answer Bot 2021-8-20

Screen Shot 2015-01-16 at 1.09.03 AM.png

AS you can see from the diagram the resistor in series by itself and the RC (resitor and capacitor) in parallel i have created a subsystem out of it. Now i am going to be using repeatedly using this model many times (say for eg. 50 times) as i am modelling a cardiovascular system. so when i change the resistor and capacitor values its only logical i use some sort of a tool where if i change the values in 1 circuit once i don't have to manually go and change the other 49 circuits as its time consuming. I heard subsystem to model conversion is useful and i did the 'right click convert to model'.

Problem is it gives this error message shown below. where it says my subsystem must be atomic, function call, triggered or enabled, what is applicable to the diagram i have?

How do i convert it to model? Can someone explain it to me thanks.

2 个评论
显示无隐藏无

Saurabh Sakpal 2015-1-15

此问题已关闭。

Answer 1

Sebastian Castro 2015-1-27

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/170043-need-help-in-converting-this-subsystem-to-model#answer_166084

Hi Saurabh,

The physical connection ports (i.e. what you see in SimPowerSystems) are not yet supported for crossing nonvirtual subsystem and model reference boundaries. This is explained in the Simscape documentation.

I would recommend converting it into a Library block instead, as shown here.

Best,

Sebastian