8051 Micro-Controller Programming Using Matlab..
3 次查看(过去 30 天)
显示 更早的评论
Can i program the Micro-Controllers such as AT89c51 Using MATLAB..
If yes then pls tell me how to do so...
Thanks in Advance
0 个评论
回答(1 个)
Walter Roberson
2011-9-30
Depends on what you mean by "program".
You would probably need a flash bios or SDRAM to load a program at boot time that would communicate over the serial port and upon command, transfer code in to memory, verify it, and then start it executing. A failsafe timeout that either interrupted or rebooted would probably not hurt ;-)
For some information on the serial port interface, see here. In that thread, Scott recommends highly against using the 8051 with the product that would later get named MATLAB Coder.
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Containers 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!